When water descends from behind a dam or weir into the river channel, it carries enormous energy that turns into high velocity, capable of scouring the bed and banks and threatening the foundations of the structure itself. Controlling this energy is therefore one of the priorities in spillway design. Stepped weirs are among the oldest and most enduring solutions: stepped spillways and weirs have been used for more than 3,500 years, and they returned to engineering attention with the spread of roller-compacted concrete (RCC) and gabions.
The idea behind steps is simple: instead of water sliding down a smooth surface and accelerating, the steps break its path and create turbulence that consumes a large part of its energy along the length of the spillway. This means that a stepped design increases energy dissipation and reduces the need for a large stilling basin at the bottom of the spillway. This approach is particularly suited to stepped weirs made of gabions.
Flow behavior over the steps changes with discharge. There are three well-known regimes: nappe flow at small discharges, then transition flow, then skimming flow at large discharges. In the nappe regime, water falls freely from the edge of each step and then strikes the next one. In the skimming regime, water flows as a coherent stream over the steps, and rotating vortices form beneath it in the cavities. These vortices draw their energy from the shear stress exerted by the main stream, and they contribute significantly to energy dissipation. In experiments on a flat stepped spillway, nappe flow appeared when the ratio of critical depth to step height (dc/h) was less than about 0.5, transition flow between 0.5 and 0.9, and skimming flow above 0.9, although these limits vary with the geometry of each spillway. The transition regime is usually avoided in design, and it has been excluded from design conditions because of previous failures.
Here a common misconception deserves correction: that fast (skimming) flow is always the most efficient at dissipating energy. The literature distinguishes between cases: in small dams, nappe flow is the most efficient, while skimming flow is the most suitable for long spillways and large dams. An experimental study showed that energy dissipation was better in the nappe regime than in the skimming regime. The advantage therefore depends on height, discharge, and slope.
The picture becomes more complex in gabion weirs, which are made of stones inside wire mesh and are therefore permeable. In laboratory experiments, the porosity of the stones was between 0.35 and 0.4. This porosity allows part of the water to pass through the steps, and observations have shown that seepage through the gabions alters the cavity flow, especially in the skimming regime. Curiously, the results did not always favor gabions: in one study, higher velocities were recorded at the end of the gabion weir in skimming flow, with less energy dissipation than in the solid weir. In another study, the rate of energy loss increased with increasing gabion porosity, and the flow shifted from nappe to skimming at high discharges, while porosity had little effect at low discharges where seepage flow predominates. This indicates that porosity, slope, and discharge interact with one another, and that gabions cannot be judged better or worse than alternatives without specifying the conditions.
Numerical studies stand out as a tool that complements laboratory experiments. Computational fluid dynamics software, such as ANSYS Fluent, allows precise analysis of the distribution of velocities, pressures, and turbulent kinetic energy (TKE). Fluent has been used to study stepped spillways, and studies have concluded that the discharge rate affects energy dissipation and shear stress. A study published in 2025 addressed the prediction of turbulent kinetic energy in a gabion stepped weir with a porosity of 0.42 and a slope of 1:2. However, these models require validation against measurements, because the structure of the air-water mixture in skimming flow is complex and interacts with flow turbulence. The choice of turbulence model, the computational mesh, and the treatment of entrapped air therefore strongly affect the results.
In design, step geometry determines much of the performance. One study showed that increasing step height raises energy dissipation when the number of steps is held constant. Beyond hydraulics, other considerations come into play: protecting the downstream bed from scour after the end of the weir, the resistance of the wire mesh to corrosion in salt-laden water, the possibility of gabion pores becoming clogged with sediment in dry valleys, and the need for periodic maintenance. These considerations remain decisive in desert valleys, where flash floods arrive suddenly and in large volumes and then dry up.
Thus, stepped weirs, including those made of gabions, offer an economical and effective solution for small and medium dams, but their performance is not a ready-made rule. Flow regime, porosity, slope, and number of steps together determine how much energy is dissipated, and the design must be verified through laboratory experiments or validated numerical modeling before construction. Those who understand these details can make the flood descend step by step, reaching the downstream calm rather than destructive.
Presented by: Asst. Lecturer Zahraa Hussein Mohammed
References
Chanson, H. (1995). Hydraulic Design of Stepped Cascades, Channels, Weirs and Spillways. Pergamon, Oxford.
Chanson, H. (2001). The Hydraulics of Stepped Chutes and Spillways. Balkema, Lisse.
Chanson, H. (1996). Prediction of the transition nappe/skimming flow on a stepped channel. Journal of Hydraulic Research, 34(3), 421–429.
Wüthrich, D., & Chanson, H. (2014). Hydraulics, air entrainment, and energy dissipation on a gabion stepped weir. Journal of Hydraulic Engineering, 140(9), 04014046.
Zhang, G., & Chanson, H. (2016). Gabion stepped spillway: Interactions between free-surface, cavity, and seepage flows. Journal of Hydraulic Engineering, 142(5).
Naseri, R., & Kashefipour, S.M. (2022). The effect of gabion stepped spillway porosity on energy dissipation and characteristics of downstream hydraulic jump of weir. Irrigation Sciences and Engineering, 45(1), 1–17.
Al-Majed, F.H., & Alabas, M.A. (2025). Modelling turbulent kinetic energy and streamlines over gabion stepped weirs. Civil and Environmental Engineering, 21(2), 864–876.